On drums...
http://ondrums.net/forum/

ACCOUSTIGATE RUBBER
http://ondrums.net/forum/viewtopic.php?f=5&t=1326		 Page 1 of 1
Author:  Gregory [ Wed May 13, 2015 10:18 am ]
Post subject:  ACCOUSTIGATE RUBBER
Until now unobtainable. Sonor neglected to indicate a Designer part number, so no one I know has been able to find one.

The thing is pretty much useless for acoustics but necessary for controlling tom wobble, and it is decidedly more convenient to use than a nut of any sort behind the tom mounted H-bracket. I will be ordering some from Germany. Anyone want to add to the order and share shipping costs? It will be a fraction of the cost of the same part in the US.

Once I've ordered a batch, I'll post the part number. I don't think there's a problem with supply but I don't want to be surprised! :lol:

Cost = 1€ each.
Author:  Gregory [ Thu Jun 25, 2015 9:39 pm ]
Post subject:  Re: ACCOUSTIGATE RUBBER
Part number SONOR 75823500. Two photos of a partially intact one pulled out of a Designer H-bracket.

They cannot be installed by hand, but need a miniature press. I mounted one using a long thin bolt, two washers, and a nut, with a brass shim wide enough to allow the rubber head to squeeze up through the hole. Even then, with the rubber fully compressed and using a lot of lubricant, I only managed to get a portion of each rubber head through the H bracket, one at a time. The rest of each head had to be levered along under the lip, being careful not to push the thing back through its hole.

It's tricky. To make an effective press, the bolt has to go through the hole in the rubber. Thus, if the bolt is too thick, the rubber will not be able to compress enough to squeeze through the bracket. I'd like to see Sonor's tool for the job.


Image

Image
Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/